Can't Filter by Set
Moderator: CCGHQ Admins
Can't Filter by Set
by CommanderJim » 24 Jul 2008, 16:41
I'm not sure if this is a problem with MWS or the masterbase, so I'm asking both the MWS support forum and here.
When I try to filter by set, where there would normally be a big checklist of all the sets (I've never actually seen this, but people say it should be there), instead all I get are a few sets that I added individually, but later just replaced with the latest GH Masterbase. Oh, and Arkomage.
I don't know why it's not recognizing any sets. I installed correctly, replacing both the "Sets" DAT file in the Data folder and the "Master.mwbase" file with the newly downloaded files. Again, it might be a problem with MWS itself, but I have no idea.
When I try to filter by set, where there would normally be a big checklist of all the sets (I've never actually seen this, but people say it should be there), instead all I get are a few sets that I added individually, but later just replaced with the latest GH Masterbase. Oh, and Arkomage.
I don't know why it's not recognizing any sets. I installed correctly, replacing both the "Sets" DAT file in the Data folder and the "Master.mwbase" file with the newly downloaded files. Again, it might be a problem with MWS itself, but I have no idea.
- CommanderJim
- Posts: 5
- Joined: 24 Jul 2008, 16:12
- Has thanked: 0 time
- Been thanked: 0 time
Re: Can't Filter by Set
by Huggybaby » 24 Jul 2008, 19:33
Have you tried a clean install? Also, try Ctrl-M to reload the masterbase.
-
Huggybaby - Administrator
- Posts: 3207
- Joined: 15 Jan 2006, 19:44
- Location: Finally out of Atlanta
- Has thanked: 701 times
- Been thanked: 594 times
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 62 guests