Can't Filter by Set

[CommanderJim]

I'm not sure if this is a problem with MWS or the masterbase, so I'm asking both the MWS support forum and here.

When I try to filter by set, where there would normally be a big checklist of all the sets (I've never actually seen this, but people say it should be there), instead all I get are a few sets that I added individually, but later just replaced with the latest GH Masterbase. Oh, and Arkomage.

I don't know why it's not recognizing any sets. I installed correctly, replacing both the "Sets" DAT file in the Data folder and the "Master.mwbase" file with the newly downloaded files. Again, it might be a problem with MWS itself, but I have no idea.

[Huggybaby]

Have you tried a clean install? Also, try Ctrl-M to reload the masterbase.