Choosing different sets

by **Doombolt1** » 25 May 2015, 13:47

I'm not sure if it's a bug or what-have-you, but when I search up a card I only see the most recent printing of the card; I don't get a choice in what set I want the card from.
This problem has only occurred recently, after I redownloaded Forge. Any ideas? Am I just missing a preference setting?

by **drdev** » 25 May 2015, 14:01

Doombolt1 wrote:I'm not sure if it's a bug or what-have-you, but when I search up a card I only see the most recent printing of the card; I don't get a choice in what set I want the card from.
This problem has only occurred recently, after I redownloaded Forge. Any ideas? Am I just missing a preference setting?

If you're in the deck editor catalog, you can click the wrench button to show a checkbox strip in which you can uncheck Unique Cards Only to show every edition of every card.

by **Doombolt1** » 25 May 2015, 16:18

Thank you immensely

by **Doombolt1** » 25 May 2015, 16:20

Also (since I haven't used forge for a while), how can I return to needing to click okay for every step? If it's possible that is. Or do I need to make a new topic for this question?

by **drdev** » 25 May 2015, 20:13

Doombolt1 wrote:Also (since I haven't used forge for a while), how can I return to needing to click okay for every step? If it's possible that is. Or do I need to make a new topic for this question?

Just click each toggled off phase to turn the stop back on.